1965-83 Avanti

1,716 topics in this forum

1. Need help indentifing carpet piece placement

   By Jim S, October 12
   • 6 replies
   • 176 views
   • 
   • brad
   • Wednesday at 09:39 PM

2. Power Steering Cylinder '83

   By GaryBe, October 15
   • 4 replies
   • 174 views
   • 
   • GaryBe
   • Tuesday at 02:30 PM

3. 1966 Avanti 1 2

   By 63stick, September 16
   • 29 replies
   • 7.8k views
   • 
   • mfg
   • October 10

4. Power Trunk Release quit

   By Kane, October 9
   • 2 replies
   • 114 views
   • 
   • Kane
   • October 10

5. Engine Swap Concerns??

   By SCPO-PD, May 7
   • 22 replies
   • 2.1k views
   • 
   • Zedman
   • October 7

6. Brake pedal goes almost to the floor before brakes engage

   By Jim S, September 19
   • 13 replies
   • 4k views
   • 
   • Jim S
   • October 3

7. Suggestions on conversion to Sanden AC system on 1967 Avanti II with SBC engine

   By Dick M, September 17
   • 3 replies
   • 1.7k views
   • 
   • Mel
   • September 23

8. 1972 front Dunlop calipers

   By Puffdaddy#1, September 16
   • 4 replies
   • 1.8k views
   • 
   • Zedman
   • September 20

9. New Shoes!!

   By GaryBe, September 2
   • 5 replies
   • 3.1k views
   • 
   • GaryBe
   • September 8

10. Hood fiberglass separating / hood hinge cause??

    By A83, August 20
    • 13 replies
    • 2.6k views
    • 
    • John D
    • September 1

11. Installed Turner Brake system and still have to push extremly hard on the pedal to stop

    By Jim S, August 29
    • 5 replies
    • 1.3k views
    • 
    • Jim S
    • August 31

12. Fuse keeps blowing in the temp, gas guage, tach and shift light circuit

    By Jim S, August 12
    • 6 replies
    • 1.4k views
    • 
    • Jim S
    • August 30

13. '72 shoulder strap roll bar pivot problem

    By Jim S, August 19
    • 7 replies
    • 2.1k views
    • 
    • 1963r2
    • August 30

14. Comparison Avanti II

    By Klaus, August 28
    • 2 replies
    • 1k views
    • 
    • Klaus
    • August 29

15. 83 Avanti starting issue

    By A83, July 20
    • 10 replies
    • 1.4k views
    • 
    • A83
    • August 22

16. What are the original carburetors and intake manifolds used on RQA 327 300hp engines? Height is an Issue.

    By Luma, May 6
    • 10 replies
    • 1.9k views
    • 
    • Jim78
    • August 13

17. Wheel Backspacing and tire questions

    By GaryBe, July 31
    • 2 replies
    • 1.1k views
    • 
    • GaryBe
    • August 1

18. POWER WINDOW REGULATOR/MOTORS (2)

    By wildfelr, August 9, 2022
    • 5 replies
    • 2.2k views
    • 
    • Skip Lackie
    • July 26

19. Everything is brand new, still overheating.

    By Jim S, June 20
    • 24 replies
    • 2.2k views
    • 
    • Jim S
    • July 22

20. Vent WIndow Frame Separated

    By A83, May 4
    • 8 replies
    • 1.7k views
    • 
    • A83
    • July 20

21. New long block engine runs well, but has some significant vibration!

    By Jim S, July 18
    • 12 replies
    • 1.3k views
    • 
    • A0136
    • July 20

22. Need part number or source for steering sector shaft seal

    By Jim S, July 17
    • 3 replies
    • 1.1k views
    • 
    • Jim S
    • July 18

23. 72 Avanti has a line coming from the fuel line drain tee.

    By Jim S, July 16
    • 5 replies
    • 1.2k views
    • 
    • Adam DeRosa
    • July 17

24. York air compressor and clutch

    By Dan Williams, July 15
    • 1 reply
    • 1k views
    • 
    • ronmanfredi
    • July 16

25. 5 MPH Bumper Buffers

    By Zedman, July 11
    • 3 replies
    • 1.2k views
    • 
    • Zedman
    • July 13