Jump to content

Installing Engine/Bell Housing alignmnet pins


mtgibby

Recommended Posts

I pulled the engine and transmission out of the R2 this weekend. The previous owner had them temp installed when they stopped the restoration.

Turns out the bell housing alignment pins are not installed.

DSC02453_zpsn52qhy66.jpg

After I center the bell housing using the alignment procedure, what is the best way to replace/install the missing pins?

Is there an off the shelf replacement?

Thanks!

Mike

Link to comment
Share on other sites

Be careful when drilling the alignment holes. Use a good and sharp drill bit and keep your drill level. The cast iron of the bellhousing is brittle and can easily crack.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...