Jump to content

Steering column attachment


Milt

Recommended Posts

Finally putting my 63 back together. Somewhere in my parts cataloging I misplaced whatever holds the steering column to the car. There are four large holes on a bracket on the column. Is this held in place by two plates and then the nuts???? Pictures/ parts catalog reference? I will more than likely be fabricating new ones if I cannot find the originals.

Thanks

Link to comment
Share on other sites

Hey Milt. There is a long bracket that runs the length of the dash right behind the dashes lower lip. There are 4 bolts on this braket you bolt the column to. I have a '63 I am planning on parting out and may be able to pull one from that car. I have some photo's of one out of the car and one installed. Send me a note via email at jimecamp@gmail.com and I will send you photo's

Jim

Link to comment
Share on other sites

Thanks for the quick respomse. I can see that bracket and the bolts. I took the steering wheel column out over a year ago to paint and cannot remember (old guy) what goes on those four bolts. The holes on the column are huge, so there must have been some pretty big fender washers or maybe two plates, one on each side.

thanks

Link to comment
Share on other sites

Oh, i get it.... that is easy. There are four large rectangular washers that are used to support the column with those large holes. The washers are just under 7/8" by 1" and 7/8 and about 3/16 thick. You could easily cut these from some 12 gauge steel, drill an 11/32 hole in the center and be good to go.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...