1965-83 Avanti

1,713 topics in this forum

1. Brake pedal goes almost to the floor before brakes engage

   By Jim S, September 19
   • 10 replies
   • 2.9k views
   • 
   • Adam DeRosa
   • 11 hours ago

2. 1966 Avanti 1 2

   By 63stick, September 16
   • 26 replies
   • 6.9k views
   • 
   • mfg
   • 23 hours ago

3. Suggestions on conversion to Sanden AC system on 1967 Avanti II with SBC engine

   By Dick M, September 17
   • 3 replies
   • 1.5k views
   • 
   • Mel
   • Tuesday at 10:53 PM

4. 1972 front Dunlop calipers

   By Puffdaddy#1, September 16
   • 4 replies
   • 1.7k views
   • 
   • Zedman
   • September 20

5. New Shoes!!

   By GaryBe, September 2
   • 5 replies
   • 3k views
   • 
   • GaryBe
   • September 8

6. Hood fiberglass separating / hood hinge cause??

   By A83, August 20
   • 13 replies
   • 2.5k views
   • 
   • John D
   • September 1

7. Installed Turner Brake system and still have to push extremly hard on the pedal to stop

   By Jim S, August 29
   • 5 replies
   • 1.1k views
   • 
   • Jim S
   • August 31

8. Fuse keeps blowing in the temp, gas guage, tach and shift light circuit

   By Jim S, August 12
   • 6 replies
   • 1.2k views
   • 
   • Jim S
   • August 30

9. '72 shoulder strap roll bar pivot problem

   By Jim S, August 19
   • 7 replies
   • 1.9k views
   • 
   • 1963r2
   • August 30

10. Comparison Avanti II

    By Klaus, August 28
    • 2 replies
    • 880 views
    • 
    • Klaus
    • August 29

11. 83 Avanti starting issue

    By A83, July 20
    • 10 replies
    • 1.2k views
    • 
    • A83
    • August 22

12. Engine Swap Concerns??

    By SCPO-PD, May 7
    • 16 replies
    • 1.7k views
    • 
    • wildfelr
    • August 17

13. What are the original carburetors and intake manifolds used on RQA 327 300hp engines? Height is an Issue.

    By Luma, May 6
    • 10 replies
    • 1.7k views
    • 
    • Jim78
    • August 13

14. Wheel Backspacing and tire questions

    By GaryBe, July 31
    • 2 replies
    • 934 views
    • 
    • GaryBe
    • August 1

15. POWER WINDOW REGULATOR/MOTORS (2)

    By wildfelr, August 9, 2022
    • 5 replies
    • 2k views
    • 
    • Skip Lackie
    • July 26

16. Everything is brand new, still overheating.

    By Jim S, June 20
    • 24 replies
    • 1.9k views
    • 
    • Jim S
    • July 22

17. Vent WIndow Frame Separated

    By A83, May 4
    • 8 replies
    • 1.5k views
    • 
    • A83
    • July 20

18. New long block engine runs well, but has some significant vibration!

    By Jim S, July 18
    • 12 replies
    • 1.2k views
    • 
    • A0136
    • July 20

19. Need part number or source for steering sector shaft seal

    By Jim S, July 17
    • 3 replies
    • 963 views
    • 
    • Jim S
    • July 18

20. 72 Avanti has a line coming from the fuel line drain tee.

    By Jim S, July 16
    • 5 replies
    • 1k views
    • 
    • Adam DeRosa
    • July 17

21. York air compressor and clutch

    By Dan Williams, July 15
    • 1 reply
    • 885 views
    • 
    • ronmanfredi
    • July 16

22. 5 MPH Bumper Buffers

    By Zedman, July 11
    • 3 replies
    • 1.1k views
    • 
    • Zedman
    • July 13

23. Vent window division seal replacement

    By Ron Dame, August 18, 2024
    • 2 replies
    • 1.4k views
    • 
    • Ron Dame
    • July 7

24. Looking for help with A/C wireing on '72

    By Jim S, May 28
    • 8 replies
    • 680 views
    • 
    • Jim S
    • July 5

25. Built in Nov 82, what is the HP rating of my 1983 Avanti

    By forward, July 4
    • 2 replies
    • 1k views
    • 
    • ronmanfredi
    • July 5